A voltage-controlled oscillator (VCO) using the timer 555

A voltage-controlled oscillator (VCO) using the timer 555 is shown in figure.

555-timer-voltage-controlled-oscillator

The circuit is sometimes called a voltage-to-frequency converter because the output frequency can be changed by changing the input voltage.

As discussed in previous blog posts, pin 5 terminal is voltage control terminal and its function is to control the threshold and trigger levels. Normally, the control voltage is ++2/3V_CC because of the internal voltage divider. However, an external voltage can be applied to this terminal directly or through a pot, as illustrated in figure, and by adjusting the pot, control voltage can be varied. Voltage across the timing capacitor is depicted in figure, which varies between +V_control and ½ V_control. If control voltage is increased, the capacitor takes a longer to charge and discharge; the frequency, therefore, decreases. Thus the fre­quency can be changed by changing the control volt­age. Incidentally, the control voltage may be made available through a pot, or it may be output of a transistor circuit, op-amp, or some other device.